AU Version 5 "REMOVE JUNK FILES"

General discussion about Acelogix Software products
radioguy1
Posts: 3
Joined: Tue May 26, 2009 3:47 pm

AU Version 5 "REMOVE JUNK FILES"

Post by radioguy1 » Tue May 26, 2009 4:41 pm

Hi
Can anyone tell me why there is a check box under "select drives" on the RIGHT SIDE OF THE SCREEN next to "Local Disc". When checked, certain junk files come out and when UN CHECKED....OTHER junk files come out. I would think it should be checked at ALL times. ALSO the box on the top in the middle of the screen that say's "SELECT DRIVES" seems to do nothing while the box on the right obviously gives some choices (drop down box) Is THAT right?

Thanks, Radioguy 1

Aneesh
Site Admin
Posts: 898
Joined: Mon Aug 04, 2003 7:12 am

Re: AU Version 5 "REMOVE JUNK FILES"

Post by Aneesh » Tue May 26, 2009 7:51 pm

* If you don't select any drives to scan, then only the files in the 'Temp' folder for your Windows-installed drive are shown. But, if you select a drive, then a full scan is done for that drive and shows all the junk files present in that drive.

* The 'Select Drive(s)' pane on the right side can be closed using the 'x' button. If so, you can use the 'Select Drives' button on the top toolbar to make the drive pane visible again.
Regards,
Aneesh,
Acelogix Software Team.

radioguy1
Posts: 3
Joined: Tue May 26, 2009 3:47 pm

Re: AU Version 5 "REMOVE JUNK FILES"

Post by radioguy1 » Tue May 26, 2009 11:22 pm

THANK YOU..............GOT IT.

Post Reply